Complete clean, disassemble, safety check, oil and reassemble (rust removal and/or exceedingly dirty firearms are extra)
Bolt Actions $50.00
Pumps, Levers & Auto Rifles $60.00
Double Rifles & Drillings $120.00
Check Headspace $25.00
Make chamber cast $50.00
Lap barrel $75.00
Cut and crown average barrel (site work extra) $60.00
Recrown only $40.00
Install new bolt handle (handle not included) prices start at $175.00
Inlet new bolt handle to stock and receiver $45.00
Checker bolt handle (per panel) $100.00
Drill and tap rifle receivers for scope mounts $60.00
Drill and tap for open sights front & rear $75.00
Drill and tap hard receivers (Springfield, Enfield, Savage 99, Ruger Mini 14) $75.00
Drill and tap for side mounts starts at $60.00
Drill and tap for peep sights $60.00
Inlet stock for peep sights or side mounts $60.00
Jewel bolt $100.00
Jewel extractor $50.00
Jewel follower $50.00
Zero in rifle at range, ammo not included $90.00
Glass bed finished rifle starts at $100.00
Install aluminum pillars and glass bed starts at $140.00
Inlet & glass bed semi-inlet stock $60/hr
Dovetail .22 rifle for tip-off rings $75.00
Dovetail for open sights (per cut) $40.00
Dovetail front and rear same set up $75.00
Trigger work on request starts at $60.00
Alter Remington model 760 from 35 Rem to 358 Win or 35 Whelen $175.00
Rechamber most rifles (bolt, extractor & feeding work additional) starts at $175.00
Mill model 70 Win & 700 Rem for stripper clip $150.00
Install swivels, Michaels or similar $25.00
Install swivels when drilling & tapping is required $30.00
Fit low swing safety (Timney, Wisner or Dayton Traister) $60.00
Convert Rem 700 to Sako style extractor (parts additional) $125.00
Install three position safety (safety not included) $60/hr
Install and fit a recoil pad or buttplate (pad/buttplate not incl.) $55.00
Custom rebarrel starting price $300.00