| Complete clean, disassemble, safety check, oil and reassemble (rust removal and/or exceedingly dirty firearms are extra) | ||
| Bolt Actions | $50.00 | |
| Pumps, Levers & Auto Rifles | $60.00 | |
| Double Rifles & Drillings | $120.00 | |
| Check Headspace | $25.00 | |
| Make chamber cast | $50.00 | |
| Lap barrel | $75.00 | |
| Cut and crown average barrel (site work extra) | $60.00 | |
| Recrown only | $40.00 | |
| Install new bolt handle (handle not included) prices start at | $175.00 | |
| Inlet new bolt handle to stock and receiver | $45.00 | |
| Checker bolt handle (per panel) | $100.00 | |
| Drill and tap rifle receivers for scope mounts | $60.00 | |
| Drill and tap for open sights front & rear | $75.00 | |
| Drill and tap hard receivers (Springfield, Enfield, Savage 99, Ruger Mini) | $75.00 | |
| Drill and tap for side mounts starts at | $75.00 | |
| Drill and tap for peep sights | $60.00 | |
| Inlet stock for peep sights or side mounts | $60.00 | |
| Jewel bolt | $100.00 | |
| Jewel extractor | $50.00 | |
| Jewel follower | $50.00 | |
| Zero in rifle at range, ammo not included | $90.00 | |
| Glass bed finished rifle starts at | $100.00 | |
| Install aluminum pillars and glass bed starts at | $140.00 | |
| Inlet & glass bed semi-inlet stock | $60/hr | |
| Dovetail .22 rifle for tip-off rings | $75.00 | |
| Dovetail for open sights (per cut) | $40.00 | |
| Dovetail front and rear same set up | $75.00 | |
| Trigger work on request starts at | $60.00 | |
| Alter Remington model 760 from 35 Rem to 358 Win or 35 Whelen | $175.00 | |
| Rechamber most rifles (bolt, extractor & feeding work additional) starts at | $175.00 | |
| Mill model 70 Win & 700 Rem for stripper clip | $150.00 | |
| Install swivels, Michaels or similar | $25.00 | |
| Install swivels when drilling & tapping is required | $30.00 | |
| Fit low swing safety (Timney, Wisner or Dayton Traister) | $60.00 | |
| Convert Rem 700 to Sako style extractor (parts additional) | $125.00 | |
| Install three position safety (safety not included) | $60/hr | |
| Install and fit a recoil pad or buttplate (pad/buttplate not incl.) | $55.00 | |
| Custom rebarrel starting price | $315.00 |
2011 All Rights Reserved
