| REVOLVERS | ||
| Complete clean, disassemble, safety check, oil, and reassemble (rust removal and/or excessively dirty firearms extra) | $60.00 | |
| Drill and tap for scope mounts | $60.00 | |
| Revolver action job/clean and smooth action (spring kit and parts additional) | $125.00 | |
| Rebarrel most revolvers, includes: remove old barrel, install factory barrel, labor only | $100.00 | |
| Install colored front sight insert | $50.00 | |
| Remove or modify hammer spur | $60.00 | |
| Convert square butt frame to round butt frame (bluing additional) | $125.00 | |
| Chamfer barrel throat | $50.00 | |
| Chamfer cylinder chambers | $60.00 | |
| Straighten crane | $60.00 | |
| AUTO SERVICES | ||
| Complete clean, disassemble, safety check, oil, and reassemble (rust removal and/or excessively dirty firearms extra) | $60.00 | |
| Drill and tap for scope mounts | $125.00 | |
| Semi-auto pistol action job: clean and smooth action, not including any parts | $120.00 | |
| Tighten slide on 1911 style | $140.00 | |
| Fit barrel to 1911 style: Non-ramped barrel | $100.00 | |
| Ramped barrel | $175.00 | |
| Fit and install barrel bushing on 1911, does not include cost of bushing | $50.00 | |
| Bevel magazine well of 1911 style frame (bluing additional) | $60.00 | |
| Checker front strap of 1911 style frame: 20 lines per inch | $200.00 | |
| 30 lines per inch | $225.00 | |
| Lower and flare ejection port (bluing additional) | $60.00 | |
| Polish barrel and feed ramp | $60.00 | |
| Fit custom trigger, does not include cost of trigger | $45.00 | |
| Fit custom hammer, does not include cost of hammer | $85.00 | |
| Mill slide for low profile rear sight | $160.00 | |
| Mill slide for front dovetail sight | $60.00 | |
| Install stake on front sight, does not include sight | $45.00 | |
| Install extended magazine release, does not include mag release | $30.00 | |
| Modify frame for beavertail grip safety, does not include safety or refinishing | $100.00 |
All Rights Reserved 2011
